Plot Mode (Plot Mode); Start Mode (Start Mode); Start Level (Start Lev.) - Unipulse TM400 Operation Manual

*1: The plotting time can be changed by setting the maximum recording time of setting values
If sample hold, peak hold or bottom hold is operated during graph plotting, the graph will be
marked.

Plot mode (PLOT MODE)

Sets the repeat condition for plotting operation.
<Setting range>
- REPEAT
- SINGLE

Start mode (START MODE)

The plotting start operation changes according to the start mode.
<Setting range>
- KEY
- EDGE↑
- EDGE↓

Start level (START LEV.)

Sets the level to be crossed.
* Enabled only when the start mode is EDGE↑ or EDGE↓.
<Setting range>
35
as follows (thin-out):
5 seconds No thin-out
10 seconds Take 1 data from 2 samples
20 seconds Take 1 data from 4 samples
40 seconds Take 1 data from 5 samples
50 seconds Take 1 data from 10 samples
100 seconds Take 1 data from 20 samples
REPEAT, SINGLE
Once the SAVE
pressed again.
Plots once if the
KEY, EDGE↑, EDGE↓
Starts taking data and plotting a graph if the
Starts taking data and plotting a graph when the torque crosses the level from
below to above after the
* The level is set by the setting value "start level".
Starts taking data and plotting a graph when the torque crosses the level from
above to below after the
* The level is set by the setting value "start level".
-9999 to 9999
20ksps
10ksps
5ksps
4ksps
2ksps
1ksps
key is pressed, plotting is repeated until the
SAVE key is pressed once.
key is pressed.
SAVE
key is pressed.
SAVE
7 Graph
SAVE key is
SAVE key is pressed.
Chapter
7
35