Table of Contents
Advertisement
5-4.
One-touch zero
This is a function to set the indicated value to zero with a single touch of key operation.
Operation procedure of one-touch zero
When not using the rotary encoder
1.
Press the
2.
The current load is reset to zero if the
The operation stops if the
When using the rotary encoder
1.
The torque display starts flashing if the
2.
The angle display starts flashing if the
3.
The flashing sensor input is set to zero if the
reset is flashing.
The operation stops if the
5-5.
ID setting (ID)
Sets the device ID of the TM400.
Separate ID can be assigned to each device.
<Setting range>
23
ZERO
key.
ESC
key is pressed.
ESC
key is pressed.
0 to 9999
5 Function Setting Procedures
SET
key is pressed.
ZERO
key is pressed.
ZERO
key is pressed once more.
SET
key is pressed while the display to
Chapter
5
23
Advertisement
Table of Contents
