Peak To Peak Hold - Unipulse TM400 Operation Manual

6 Hold Function
6-5.

Peak to peak hold

Holds the difference (range) between the peak and bottom values of torque.
- Operation of peak to peak hold (start mode: key)
HOLD
HOLD display
Holds the input at the
input values as the indicated value.
Chapter
6
Press the
Press the
- Operation of peak to peak hold (start mode: level)
HOLD
HOLD display
The hold operation starts when the torque passes the start level (from above to below or from below
to above) after pressing the
passes the stop level (in the opposite direction of the start level). After the passing the stop level, the
hold data is displayed while monitoring the indicated value to pass the start level.
Press the
30
30
Indicated value = 0
key input
Lights off
HOLD
HOLD
key again to confirm.
key again to stop hold operation.
HOLD
Detection/hold
section
Indicated value = 0
key input
Lights off
Flashes
key again to stop hold operation.
HOLD
Detection/hold section
Flashes
key down as the standard value, and the maximum difference of the
Detection/hold
Hold fix section section
Lights on Flashes
key. Afterwards, the hold operation continues until the torque
HOLD
Hold Hold release
fix section section
Standard line
Time
Lights on Lights off
Hold release
section
Start level
(Standard line)
Stop level
Time
Lights Lights off
on
Torque
Indicated value
Torque
Indicated value