Table of Contents
Advertisement
7 Graph
Stop mode (STOP MODE)
Sets the stop mode for graph.
Maximum recording time (MAX.REC.TM)
The maximum time for recording is set by this function.
Pretrigger (PRETRIGGER)
Plots a graph by tracing back the length of time set as a rate against the full scale.
* Enabled only when the encoder is not used and the start mode is EDGE↑ or EDGE↓.
X-axis start point (X START)
Chapter
7
Sets the start point for X-axis of a graph.
* Enabled only when the encoder is used.
X-axis scale (X SCALE)
Sets the X-axis scale of a graph.
The X-axis scale can also be changed on a graph display screen (
36
36
<Setting range>
CYCLE, MAX. REC.
- CYCLE
Use of encoder
Not used:
Used:
- MAX. REC.
Stops plotting when the graph is plotted up to the maximum recording time.
The graph will be overwritten.
<Setting range>
5, 10, 20, 40, 50, 100 [S]
<Setting range>
OFF, 10, 20, 30, 40, 50 [%]
<Setting range>
-1000000 to 1000000
<Setting range>
Encoder enabled
10, 20, 40, 80, 100, 200, 400, 800, 1000, 2000, 4000, 8000, 10000,
20000, 40000, 80000, 100000, 200000
(Decimal place is automatically determined according to
the minimum scale setting.)
Encoder disabled
0.001, 0.002, 0.004, 0.008, 0.01, 0.02, 0.04, 0.08, 0.1, 0.2, 0.4, 0.8,
1, 2, 4, 8, 10, 20 [s]
* The settable range changes depending on the setting
of maximum recording time.
Stops plotting when the graph is plotted up to the X-axis
full scale or the maximum recording time.
Stops plotting when the graph is plotted up to the timing of
the angle to be reset to 0 (set by the setting value "zero clear") or
the maximum recording time.
5s ...........0.001 to 1
10s .........0.001 to 2
20s .........0.001 to 4
keys).
40s ........ 0.001 to 8
50s ........ 0.001 to 10
100s ...... 0.001 to 20
Advertisement
Table of Contents
