Usb Interface Setting; Communication Format For Commands - Unipulse TM400 Operation Manual

USB interface setting

Set the USB I/F setting of the TM400. The I/F setting is transmission.
Baud rate (BAUDRATE)
<Setting range>
Data bit (DATA BIT)
<Setting range>
Stop bit (STOP BIT)
<Setting range>
Parity bit (PARITY BIT)
<Setting range>
Delimiter (DELIMITER)
<Setting range>
Received characters (REC. CHAR.)
<Setting range>
Send characters (SEND CHAR.)
Transmits forcibly the same data as RA command.

Communication format for commands

- Writing setting values
Host
W
TM400 reply
Setting value No.
* Refer to P.43 "n Setting value communication format" for setting value No.
- Reading setting value
Host
W
TM400 reply
Setting value No.
* Refer to P.43 "n Setting value communication format" for setting value No.
39
9600, 19200, 38400, 57600, 115.2k, 230.4k, 691.2k [bps]
7, 8 [bit]
1, 2 [bit]
NON, EVEN, ODD
CR, CR+LF
ASCII 0 to 9, A to Z
(Small letters are also displayed as capitalized.),CR, LF, ■ (others)
Sign
(0 or +: positive -: negative)
Setting value
(8-digit, no decimal point)
CR
W
Sign
(0 or +: positive -: negative)
Setting value No.
(8-digit, no decimal point)
* Character: ASCII
CR
* No return data
* Character: ASCII
Delimiter
Setting value
8 USB Interface
Chapter
8
39