Drive Belt - BRP Can-am MAVERICK Trail T Series Operator's Manual

tmo2016-010-036_a
TIGHTENING TORQUE
CVT cover
screws

Drive Belt

Drive Belt Removal
NOTICE
In case of a drive belt fail-
ure, the CVT, cover and air outlet
must be cleaned.
Please refer to
ING DRIVE BELT DURABILITY
SIC PROCEDURES
IMPORTANT information.
CVT COVER
Remove
Open driven pulley.
REQUIRED TOOLS
PULLER/LOCKING
TOOL (P/N 529
000 088)
DRIVEN PULLEY
ADAPTER (P/N 708
200 720)
Insert adaptor in threaded hole of
driven pulley.
Screw tool in the threaded hole of
adaptor.
Tighten to open the pulley.
7 N•m ± 0.8 N•m
(62 lbf•in ± 7 lbf•in)
TIPS FOR MAXIMIZ-
in
section for some
.
tmo2016-010-093_a
TYPICAL
1. Fixed sheave of driven pulley
2. Adaptor
3. Puller/locking tool
4. Wrench
To remove belt, slip the belt over the
top edge of fixed sheave, as shown.
BA-
tmo2016-010-094_a
TYPICAL
Drive Belt Installation
For installation, reverse the removal
procedure. Pay attention to the follow-
ing details.
The maximum drive belt life span is
obtained when the drive belt has the
proper rotation direction. Install it
so that the arrow printed on belt is
pointing towards front of the vehicle,
viewed from top.
______________
MAINTENANCE PROCEDURES
119