BRP Can-am MAVERICK Trail T Series Operator's Manual page 110

MAINTENANCE PROCEDURES
XPS RECOMMENDED ENGINE OIL
Scandinavia:
4T 5W40 SYNTHETIC
BLEND OIL (EUR)
(P/N 779290)
General
purpose Other Countries:
4T 5W40 SYNTHETIC
BLEND OIL
(P/N 779133)
Scandinavia:
4T 0W40 SYNTHETIC
OIL (EUR) (P/N 779286)
Cold
Other Countries:
temperature
4T 0W40 SYNTHETIC
OIL (P/N 779139)
Scandinavia:
4T 10W50 SYNTHETIC
OIL (EUR) (P/N 779240)
Warm
temperature Other Countries:
4T 10W50 SYNTHETIC
OIL (P/N 779234)
IF THE RECOMMENDED XPS
ENGINE OIL IS NOT AVAILABLE
Use a 4-stroke SAE engine oil
meeting or exceeding the following
lubricant industry specifications.
Always check the API service label
certification on the oil container, it must
contain at least one of the indicated
standards.
– API service classification SJ, SL,
SM or SN
Engine Oil Change
CAUTION The engine oil can
be very hot. Wait until engine oil is
warm.
NOTICE
Engine oil and oil filter
must be replaced at the same time.
Bring engine to its normal operating
temperature.
Place vehicle on a level surface.
Place a drain pan under the engine
drain plug area.
______________
108
Clean the drain plug area.
Unscrew drain plug and discard the
gasket ring.
tmr2011-010-003_a
1. Gasket ring
2. Drain plug
Remove the dipstick.
Allow oil to drain completely from the
crankcase.
Clean the magnetic drain plug from
metal shavings and residue. Presence
of debris gives an indication of internal
engine damage.
Install a NEW gasket ring on the drain
plug.
NOTICE
Never use the gasket ring
a second time. Always replace by a
new one.
Install and tighten drain plug to the rec-
ommended specification.
TIGHTENING TORQUE
Drain plug
Replace oil filter. Refer to
Refill engine with recommended en-
gine oil.
For engine oil capacity, refer to
FICATIONS
.
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)
OIL FILTER
SPECI-
.