BRP Can-am MAVERICK Trail T Series Operator's Manual page 114

MAINTENANCE PROCEDURES
2. Remove the cooling system pres-
sure cap.
219001880-034_a
1. Pressure cap
3. Unscrew coolant drain plug and
drain the coolant into a suitable con-
tainer.
NOTE: Do not unscrew the coolant
drain plug completely.
219001880-067_a
1. Oil filter cover
2. Water pump cover
3. Coolant drain plug
4. Disconnect the lower radiator hose
and drain the remaining coolant into
a suitable container.
NOTE: Take note of the position of the
hose clamp on the lower radiator hose
at the radiator.
______________
112
219001880-035_a
TYPICAL
1. Lower radiator hose to disconnect
5. Drain cooling system completely.
6. Reinstall cooling system drain plug
and tighten to specification.
TIGHTENING TORQUE
Coolant drain
plug
7. Reinstall radiator hose and hose
clamp as noted prior to removal.
TIGHTENING TORQUE
Radiator hose
clamp
8. Fill cooling system with coolant,
COOLING SYSTEM BLEED-
refer to
ING
procedure.
Cooling System Bleeding
1. Remove the pressure cap.
2. Fill coolant system until it is full up to
the Max line on the coolant tank.
tmo2016-010-004_a
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
3 N•m ± 0.5 N•m
(27 lbf•in ± 4 lbf•in)