Table of Contents
Advertisement
Password
When you purchase an NETS, it comes with password protection by
default. The initial password is "77559"; 5 digits. You can disable all
passwords or change the password.
If your scale has password
protection enabled, then you can change the password by following the
instructions in the General Programming section under Password
Change. If your scale has password protection disabled or you wish to
disable password protection, you must contact your ACOM Dealer to
change this feature.
Changing this feature is only permitted by
licensed individuals.
There are only two places where the NETS will show the password
entry screen: 1 to enter the Main Menu and 2 to void PLU sales. If
you press SET or
from Sales Mode (Initial State) you will see
Func.
the following screen:
This is your cue to enter the password; of course, if passwords are
disabled then this screen will always be skipped. For a new scale, you
would simply press
PRINT and then
5
5
7
7
9
the scale will proceed to the next screen.
Passwords are composed of the numbers 0 to 9. As you type your
password, the Total Price display will display a dash for every number
that you press. When you are done entering your password, press
PRINT . If you entered the correct password you will go on to the next
screen; if not, you will remain at the password entry screen.
If you wish to exit the password entry screen, press
and you
ESC
will go back to Sales mode. Do not forget your password; write it down
somewhere safe. If you forget your password, you will NOT be able to
access the scale; the only way to correct this problem is to call your
ACOM Dealer who may have to clear out ALL of the scale's memory
and completely reprogram the scale, which may or may not incur
additional charges. Note: if you wish not to use passwords, have your
ACOM Dealer set your scale up accordingly.
20
Advertisement
Table of Contents
