Table of Contents
Advertisement
free. With that in mind, please make sure that the power outlet used
with the NETS is a dedicated line with no high-noise devices (such as
compressors, motors, etc.) plugged into the same line. Also, make
sure that the wiring for the outlet is correct. If you are uncertain,
please contact a certified electrician or your local Dealer.
Be sure to check the NETS Specification Plate located on the left side
of the scale. The power supply specifications are listed there.
Quick Start
To get started immediately, follow the instructions in the "ACOM NETS
Quick Reference Guide" that is included with your scale.
recommend that you read this manual at least once.
Reference Guide states the following:
A. Basic setup:
1.
Take the scale, pole display, platter, and accessories bag
out of the box.
2.
Install the pole display: Note: Make certain that none of
the wires are being crimped when you are installing the
pole display.
3.
Place the scale in the area where it will be used which
should be a rigid and level surface. Using the leveling
feet and leveling gage, make sure that scale is level. The
leveling gage is located on the right-side rear of the scale
by the pole bracket; the leveling feet are located at the
bottom of the scale chassis.
located on the front-right side of the bottom of the scale
(closest to the numeric keypad) is not adjustable. Please
do not try to adjust this leveling foot; instead, use the
other three feet to adjust the level.
a.
Connect the display connectors together.
b.
Place the Pole Display properly into the bracket
making sure that the connectors are slipped
inside of the pole (upwards.)
c.
Attach the two display pole screws (2 larger
screws) to securely fasten the pole to the bracket.
d.
Finally, attach the bracket-plate to the bracket
and fasten it with the 4 smaller screws.
Note:
18
We still
The Quick
The leveling foot
Advertisement
Table of Contents
