Table of Contents
Advertisement
Do's & Don'ts
Please observe the following:
Unplug and shut the scale OFF whenever you are changing the
label roll or working in the printer bay.
The outlet that the scale is plugged into should be properly
grounded and have the correct voltage supply.
Maintain a static free work area.
Never use any other equipment on the same electrical line; the
scale should have a dedicated line.
Place the scale far from strong RF (radio frequency) interference.
Level the scale using its adjustable feet; however, be careful not
to try and adjust the foot that is under the printer towards the front
of the scale.
Do not subject the platter to sudden impacts or drop anything onto
the platter.
Do not spill the water or any other liquid on the scale.
Do not use any solvents to clean the scale.
Do not remove the safety ground on the power cord.
Do not store thermal labels where they may be subject to: direct
sunlight, high humidity, high temperature, or dust. Doing so may
damage and/or hinder the quality of the print on the labels. Be
sure to also follow any other label-manufacturer guidelines.
Do not press the keys using excessive force; the keys will operate
correctly if they are pressed lightly. If any keys should fail to work,
please contact your ACOM Dealer.
Do not use any label media other than that recommended by
ACOM. Please contact your ACOM Dealer for details.
Do not attempt to affect repairs to this equipment; unlicensed
individuals affecting repairs on legal for trade devices can be
subject to fines in all 50 states as well as voiding your warrantee.
Contact your local ACOM Dealer for service or repairs.
14
Advertisement
Table of Contents
