Table of Contents
Advertisement
4.
Place the platter on the scale platform and then connect
the AC cord to the NETS. The AC cord (power cord) goes
connected to the left-side of the scale; there is a label on
the scale by the connector ports which indicates what
each connector is for.
5.
Make sure that the power switch is in the OFF position
which is located above the AC cord connector.
6.
Plug the scale into an AC source. Note: The AC source
must be 85V ~ 240V DC 50/60 Hz +2%.
7.
Turn the power switch to the ON position. The scale will
do the display test and then go to zero.
8.
Press the
they are fed out each time you press the key.
9.
The scale should be in the Initial State; all the displays
should read:
This is the Initial State. Most directions and instructions in this manual
will begin with setting the scale up to the Initial State.
familiarize yourself with how to get the scale to the Initial State: this
state is achieved by simply turning the scale on. You are now ready to
use the scale.
key 2 or 3 times collecting the labels as
FEED
19
Please
Advertisement
Table of Contents
