Adam Equipment NETS ME Price Manual page 15

2) Remove and
discard the
cardboard label core
which should be
located on the Label
Roll Spool (b)
making sure NOT to
throw out the Label
Roll Spool (b). Make
sure to also discard
any excess labels
and/or backing paper
along the label path.
The label path is
shown in red on the
Installation sticker in
the cassette drawer.
Installing Labels:
Once you have followed the
instructions for removing labels you
can install a new label roll by taking
the new label roll and remove about
30 cm (approx. 12") of labels from the
backing paper of the new label roll
and then do the following:
1) Place the new label roll onto the
Label Roll Spool (b).
2) Thread the backing paper through the Pressure Plate (c).
3) Next, thread the backing paper between the Label Guide bobbin (g)
and (h).
4) Then, thread the backing paper over the Platen (d) and over the
Label Guide bobbin (i) so that the backing paper is NOT between
Platen (d) and the Label Guide bobbin (i).
9