Basic Parameters - Alphatech A-VarioBell User And Service Manual

5.3 Basic parameters

Parameter Value
41
v – type of choice v=0 is DTMF tone choice, v=1 is impulse choice
Parameter Value
42
z – sign for prolonging a call * or # (10secs. before the end of the call the A-
VarioBell sends signal, after pressing this the A-VarioBell prolongs the
call)
Parameter Value
43
g – Command order [1-2] (there are 2 to disconnect the A-VarioBell from
both relays)
bb – Command for disconnecting the A-VarioBell from the phone [2 spaces]
1
/ It is advantageous to set the same command for relay switching on
(parameter 35,36)
or aa=cc.
– command is always 2 digits, but if you wish to control relay with a single
1
/
digit from the phone, there is an option to input "*a", where a is a single
number and the star represents an empty space and must be in the first
place
(e.g. at parameters 35,36).
Parameter Value
44
xxxx – service password to programme from a phone (DTMF)
If you forget the password, the following procedure is recommended:
1. Open the A-VarioBell front cover;
2. Switch 'DIP 1' to 'ON';
3. Call the A-VarioBell;
A-VarioBell – User and service manual
46
Meaning
Type of choice v – time/impulse
v
Meaning
z
Sign for call prolonging
Meaning
Command for disconnecting A-VarioBell
g bb
from the phone
99,*0-*9)
and command for the A-VarioBell disconnection aa=bb
Meaning
xxxx
Service password
Default
(0/1)
Default
(* / #)
Default
155 266
(00-
Default
(0000-9999)
0
*
0000