Parameters Programming; Programming By Phone; Programming Enter - Alphatech A-VarioBell User And Service Manual

4

Parameters programming

4.1 Programming by phone

4.1.1 Programming enter

A-VarioBell dveřní vrátný se uvede do režimu programování dvojím
způsobem:
1. By password – incoming calls only! – pick up a phone and dial the
number that the A-VarioBell is connected to
branch, if you are connected to a switchboard line, or the number of the line to
the building, where the A VarioBell is installed and ask to be connected to the
extension where is A VarioBell connected)
(you will hear the pick-up tone – see chapter 9) within 10 secs. press
'#xxxx', where xxxx is the service password to enter the programming
(in the basic setting xxxx=0000)
a programming entry tone followed immediately by a programming
tone).
2. By DIP 1 "SERVIS" – incoming call only! – connect to the A-VarioBell
as in part 1 above, but where the DIP switch is in position 1 "on", the A-
VarioBell will go directly to the programming mode – you will hear the
pick-up tone for entry to programming followed immediately by the
programming tone)
Do not forget to put DIP switch to position "off" at the end .
4.1.2 parameters programming
The default state for programming is announced with a programming
tone, the A-VarioBell always returns to this state after a specified time (5sec),
whether you started programming or not.
There are two types of parameters used during programming. These are
parameters with a fixed length, which is the majority of them, when
programming is confirmed after it fulfils the mandatory length and is
immediately 'written in' with a confirming tone and parameters with variable
length (parameters 1,2,32,33,34) when the confirmation is made only after
time of inaction (5 sec). The only case when there is an immediate 'writing in'
of parameters is when the maximum number of 'written in' signs (numbers) are
filled up, for parameters 1 and 2 it is 24, for parameters 32,33,34 it is 6.
If you input a number (sign) that is unacceptable during the programming
the A-VarioBell immediately sends an error tone, the parameter is not 'written
in 'and the A-VarioBell reverts to a default state where it is possible to either
repeat the parameter programming or start programming a different parameter.
The A-VarioBell will automatically disconnect form the programming
regime after a period of inaction, 30 sec. With each DTMF tone dialled the time
will always resets to 30 sec. It is also possible to end the programming mode
by choosing parameter 9.
. The A-VarioBell will pick up
When password is correct there will be
A-VarioBell – User and service manual
(either the number of the
37