System Parameters - Alphatech A-VarioBell User And Service Manual

5.5 System parameters

Parameter Value
61
The A-VarioBell's comes with standard acoustic signals.
parameter "z" it is possible to switch off the acoustic signals. The values are:
z=0 Acoustic signals off; and
z=1 Acoustic signals on.
Parameter Value
62
The acoustic signals for the connection and disconnection of a line are standard,
but this may cause false choices with some phone systems. So using parameter
"v" it is possible to switch off these signals. The values required are:
z=0 Introduction/conclusion signalisation is off;
z=1 Pick up and disconnection signalisation on (intro/concl.- type1);
z=2 Pick up and disconnection signalisation on (intro/concl.- type2).
Parameter Value
63
Ticking during a call is switched off as standard. However, by switching it on you
can differentiate on the switchboard a call from the A-VarioBell by a faint ticking.
The values are:
u=0 Ticking into a call is off
u=1 Ticking into a call is on
Parameter Value
64
The external power supply is turned off as standard.
You only need to turn this function on if the A-VarioBell is supposed to operate
functions when at rest (i.e. relay control).
permanent switch-on even after call disconnection, regime m=8 enables
switch-on depending on the Day/Nigh setting even after call disconnection. In
these cases it is necessary to connect an internal power supply so that there is
no current flowing through the A-VarioBell when the system is at rest.
Meaning
Acoustic signals (confirmation, error,empty
z
memory, end of call)
Meaning
Acoustic signals introduction/conclusion
v
Meaning
Acoustic ticking signal during a call
u
Meaning
Internal power supply from connected
w
supply 12V (DIP 3,4)
Relay in regime m=7 enables
A-VarioBell – User and service manual
Default
1
(0/1)
However, using
Default
1
(0/1/2)
Default
0
(0/1)
Basic
0
(0/1)
53