62 | Performance Series Full Poe Embedded NVR Remote User Guide
Configuring Switch Settings
You can change the IP Address, Subnet Mask, and Default Gateway for setting the PoE switch
settings.
1.
2.
3.
Configuring Event Settings
Configuring Video Detection
Motion Detection Configurations
You can configure the system to generate a motion detection alarm when the minimum amount
of motion (as defined by you) is detected in the video.
Click Detect under EVENT to open the Motion Detect configuration interface.
www.honeywell.com/security
Click Switch under Network to open the Switch interface.
Figure 3-33
Switch Configuration Interface
Configure the following settings:
Table 3-13
Switch Configurations
Configuration
IP Address
Subnet Mask
Default Gateway
Click Apply to save your settings.
Description
Enter a new IP address.
Enter a new subnet mask.
Enter a new default gateway.