H D 2 - D M - A / D M - A M
HD2-DM-A Mounting on Motherboard
The Diagnostic Module HD2-DM-A must only be mounted on the respec-
tive slot. The Mounting slot is marked with „Diagnostic Module only"
The housing of HD2-DM-A meets the degree of protection class IP 20. It
is intended for mounting on the Fieldbus Power Hub motherboards
MB-FB-*.
1. Carefully center the polarisation holes and mate the two con-
nectors, then gently press down the module (figure 1).
2. Push down the red „Quick-LOK" tabs on each side of the module
to fix it to the panel (no tools required, see figure 2).
The module is mounted.
•
Dismounting the modules
1. Push the red „Quick-LOK" tabs upwards and
2. Lift off the entire module gently
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
Application Engineering HD2-DM-A
Copyright Pepperl+Fuchs, Printed in Germany
27