Pepperl+Fuchs FieldConnex HD2-DM-A Manual page 54

FDS and OPC Server
Name
FDSOPCService.DA Name of the OPC service (PROG_ID)
FDS
Port
DMA 001 (1-4)
State
SummarizedState
Value definitions and priorities
State value
0
1
2
3
4
State Data Quality
BAD, Comm_FAILURE A communication error between OPC Server
BAD, NON_SPECIFIC FDS Server has not polled the Diagnostic
BAD,
OUT_OF_SERVICE
UNCERTAIN,
NON_SPECIFIC
GOOD
Subject to reasonable modifications due to technical advances.
54
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
TAG of the FDS server
TAG of the FDS Port
TAG of the Diagnostic module and the appro-
priate segment
Describes the current status of the node by the
following values:
0: Good
1: Maintenance Required
2: Out of Specification
3: Hardware Error
4: Communication Error
(Meanings see below)
Provides the highest prior State data value and
the highest prior State data quality for the actu-
al node and all subordinated nodes.
(Priorities see below)
Meaning
Good
Maintenance required
Out of Specification
Hardware error
Communication error
and FDS Server has occured.
Module yet (temporary state)
A segment is disabled
Occurs if the Diagnostic Module is connected
via the FDS to a Pepperl+Fuchs Fieldbus
Gateway, which also process alarms. This is
an invalid operating state.
None of the above applies.
H D 2 - D M - A / D M - A M
Meaning
Meaning
Copyright Pepperl+Fuchs, Printed in Germany