Table of Contents
Advertisement
Operation with the Diagnostic Manager
•
Figure 8.22: Control panel Overview
1
Start / Cancel signal recording (depending on the system a reac-
tion delay of up to 5 sec. is possible)
2
Recording length, default value = 32.768 ms / sample rate = 2
MSample (64 KB/8 Bit, if you extend the recording length, the
sample rate is reduced)
3
Sampled amplitude
4
Trigger events (see chapter Trigger events FF/PA)
5
Trigger address, usage of the Trigger events on a specific physi-
cal bus address / field device address)
6
Pretrigger time, selection of the recorded signal length before
Trigger event occurs
7
Trigger level, selection of the triggered signal limit
(-0.65 V...+0.65 V)
8
Trigger timeout
Subject to reasonable modifications due to technical advances.
84
Pepperl+Fuchs Group • Tel.: Germany +49 621 776-0 • USA +1 330 4253555 • Singapore +65 67799091 • Internet http://www.pepperl-fuchs.com
2
3
4
6
7
8
H D 2 - D M - A / D M - A M
Copyright Pepperl+Fuchs, Printed in Germany
Advertisement
Table of Contents
Troubleshooting
