Table of Contents
Advertisement
Safety and Information
Keysight Technologies N9030-90061
Use the Keysight supplied power cord or one with the same or better
electrical rating.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock do not remove covers.
The Mains wiring and connectors shall be compatible with the
connector used in the premise electrical system. Failure to ensure
adequate earth grounding by not using the correct components may
cause product damage and serious injury.
If this product is not used as specified, the protection provided by the
equipment could be impaired. This product must be used in a normal
condition (in which all means for protection are intact) only.
Safety of any system incorporating the equipment is the responsibility
of the assembler of the system.
This instrument has auto-ranging line voltage input. Be sure the
supply voltage is within the specified range and voltage fluctuations
do not to exceed 10 percent of the nominal supply voltage.
Before using your converter module, please read all documentation from
VDI (included on the USB drive). It is important to follow the General
Operating Procedures and Guidelines section.
This product has been designed and tested in accordance with accepted
industry standards and has been supplied in a safe condition. The
documentation contains information and warnings that must be followed
by the user to ensure safe operation and to maintain the product in a safe
condition.
Only Keysight approved accessories shall be used.
The main power cord can be used as the system disconnecting device. It
disconnects the mains circuits from the mains supply.
9
Advertisement
Table of Contents
