Setting-Out Line Line - Sokkia CX Series Operator's Manual

4. Press [OK] to return to the screen
in step 2.
• [MOVE]: Permanently moves
the baseline coordinates by the
amount set in <Baseline offset>.
5. Press [OK] on the screen of step
2. The coordinate value of the
required point is calculated, taking
into account the movement of the
baseline, and displayed.

16.3 Setting-out Line Line

Setting-out line line measurement tells how far horizontally the measured point is
from the baseline and how far vertically the measured point is from the connected
line. The baseline can be offset in a horizontal direction if necessary.
• Before performing setting-out line line, the baseline must be defined.
Profile View
1st Pt.
PROCEDURE
1. Select "Line" in <Set-out line>.
S e t - o u t l i n e
N
E
Z
REC
Measured Point
Baseline
Length
Offset (horizontal direction)
Measured Point
Cut
S e t - o u t l i n e
16. SETTING-OUT LINE
185.675
102.482
9.662
Offline (--)
2nd Pt.
P o i n t
L i n e
S-O
99