Sokkia CX Series Operator's Manual page 217

2. Press [TOPO] in the third page of
OBS mode to display <TOPO>.
Select "Coord data" to display the
measurement results.
3. Set the following items.
(1) Target height
(2) Code
(3) Point name
4. Check the input data, then press
[REC] to confirm the angle and
coordinate measurement value
and record the data.
5. To continue measurement, sight
the next point, press [MEAS], then
perform steps 3 and 4 above.
Angle value is displayed in real
time until [REC] is pressed.
• Pressing [AUTO] will start
measurement, and automatically
record the measured results. It is
convenient to record measured
data without setting the point
name, code, and collimation
height.
• Press [OFFSET] to start offset
measurement.
• Before measurement, [0SET] is
displayed instead of [OFFSET].
The horizontal angle can be set
to 0.
6. Press {ESC} to quit measurement
and restore <TOPO>.
28. RECORDING DATA - TOPO MENU -
TOPO JOB1
Occupy
BS data
Angle data
Dist data
Coord data
N
E
Z
HR
CD
REC OFFSET AUTO
MEAS
207