Distance Setting-Out Measurement - Sokkia CX Series Operator's Manual

15. SETTING-OUT MEASUREMENT

15.2 Distance Setting-out Measurement

The point to be found based on the horizontal angle from the reference direction
and the distance from the instrument station.
PROCEDURE
1. Press [S-O] in the third page of
the OBS mode screen to display
<S-O>.
2. Select "Occ.orien." to set the
instrument station data and azimuth
angle of the backsight point.
"13.1 Entering Instrument
Station Data and Azimuth
Angle PROCEDURE Reading
in Registered Coordinate
Data"
3. Select "S-O data."
4. Press [DISP] to change the
distance input mode to <S-O H>.
• Each time [DISP] is pressed: S-
O Coord (coordinates), S-O HD
(horizontal distance), S-O SD
(slope distance), S-O VD (height
difference), S-O Ht. (REM
measurement).
15.1 Coordinates Setting-out
Measurement, 15.3 REM
Setting-out Measurement
86
S-O HD
H d i s t :
H a n g :
LOAD DISP
0 . 0 0 0 m
OK