Sokkia CX Series Operator's Manual page 198

Compact x-ellence station
Table of Contents

Advertisement

25. ROUTE SURVEYING
PROCEDURE Using observation to specify arbitrary width pegs
1. Enter the road topo menu in the same
manner as shown above.
"PROCEDURE Using key entry
to specify arbitrary width pegs"
steps 1 to 3
2. Sight the width peg and press [MEAS]
to start measurement. The
coordinates and measurement
distance of the width peg, vertical
angle and horizontal angle are
displayed.
Press [STOP] to stop the
measurement.
3. The coordinates and point name
shown in this screen are used to
display the results for the center peg.
4. Press [YES] in the screen shown in
step 3 to display the route width and
point name of the width peg.
5. The next width peg can then be set by
pressing [OK].
• The rules regarding the assigning of point names to width pegs and center pegs
are the same as those for when calculating width pegs in automatic calculation
of cardinal points.
"25.8.5 Automatic calculation of cardinal points
assigning of point names to automatically calculated pegs"
• The rules regarding the assigning of point names to center pegs are the same
as those for when calculating arbitrary points.
188
A l i g n m e n t / R o a d t o p o
N p :
E p :
LOAD
MEAS
N
1 6 8 . 3 2 9
E
1 9 9 . 3 6 1
3 . 7 8 0 m
SD
7 8 4 3 ' 2 6 "
ZA
2 1 4 7 ' 1 6 "
HA-R
A l i g n m e n t / R o a d t o p o
N p :
1 6 8 . 3 2 9
1 9 9 . 3 6 1
E p :
C o n f i r m ?
Road topo/CL peg
N
173.318
E
196.031
Sta..ing
123.456m
No.2
REC
Rules regarding the
0 . 0 0 0
0 . 0 0 0
OK
STOP
NO
YES
S-O
OK

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cx-101Cx-102Cx-102lCx-103Cx-105Cx-105l ... Show all

Table of Contents