Sokkia CX Series Operator's Manual page 84

13. SETTING INSTRUMENT STATION
• Pressing [REC] displays the
backsight point recording
screen. Press [OK] to the
following data.
Instrument station data,
backsight station data, known
point data, and angle
measurement data (distance
measurement data when
[MEAS] is pressed)
Pressing [NO] returns to the
instrument station setting screen
without setting the direction angle.
From here, set the backsight point
again.
• Even if "inch" is selected in Config mode, standard deviation is displayed in
"feet" or "US feet" depending on the feet unit selected.
13.2.2 Height Resection Measurement
Only Z (height) of an instrument station is determined by the measurement.
• Known points must be measured by distance measurement only.
• Between 1 and 10 known points can be measured.
PROCEDURE
1. Select "Occ.orien." from the
coordinate measurement menu.
2. Press [RESEC] in the "Occ.orien."
74
ZA 8 0 3 0
HA-R 1 2 0 1 0
HR
CD
100.001
N0:
100.009
E0:
Z0:
PT PNT-001
HI
LOAD BS AZ BS NEZ RESEC
1 0
0 0
1.400m
OK
9.999
1.200m