Sokkia CX Series Operator's Manual page 194

25. ROUTE SURVEYING
• When "Existing pt" in step 4 has been
set to "Skip" a point with a point name
which already exists in the current
JOB will not be automatically stored.
These points are marked with "*". At
this stage of the process it is possible
to store such a point under a new
point name.
6. The screen at right is displayed when
the amount of set pegs exceeds 600
points. Press [YES] to continue using
the initial 600 points.
Press [NO] to return to the screen of
step 4.
7. Press [OK] to return to <Alignment>.
• The center peg can be set-out by
pressing [S-O].
"15. SETTING-OUT
MEASUREMENT"
• Peg No. pitch input range: 0.000 to 9999.999 (10.000*) (m)
• Route width input range: -999.999 to 999.999 (Null*) (m)
• Duplicate point name procedure: Add (record as separate point with same point
name)*/Skip (no overwrite)
• Maximum point name length: 8 characters ("peg No."*)
• Cardinal point settings are retained even when the power has been cut off.
However, the settings have been cleared if "RAM cleared" is displayed.
Rules regarding the assigning of point names to automatically
calculated pegs.
• Clothoid curve cardinal point: the curve number is added at the end e.g. the
KA1 Point of curve number 1 is written "KA1-1", and the KA1 Point of curve
number 2 is written "KA2-1".
• Circular curve cardinal point: the curve number is added at the end e.g. the
BC Point of curve number 1 is written "BC1", and the BC Point of curve
number 2 is written "BC2".
184
Results
N
2 0 0 . 0 0 0
E
4 0 0 . 0 0 0
P T
E P
REC
M e m o r y o v e r
C o n t i n u e ?
S-O OK
YES NO