Setting-Out Line Line - Sokkia im-101 Operator's Manual

2. Press [OFFSET] to display <Baseline offset>.
3. Set the following items.
(1) Incr: Increment by which offsets can be decreased/
increased using the arrow softkeys.
(2) Length: Lengthwise offset
(3) Lateral: Lateral offset
(4) Height: Elevation offset
(5) Rt.ang: Rotation angle offset
• []/[]: Press to decrease/increase the value by the
amount set in "Incr".
4. Press [OK] to return to the screen in step 2.
• [MOVE]: Permanently moves the baseline coordinates by
the amount set in <Baseline offset>.
5. Press [OK] on the screen of step 2. The coordinate value of
the required point is calculated, taking into account the
movement of the baseline, and displayed.

16.3 Setting-out Line Line

Setting-out line line measurement tells how far horizontally the measured point is from the baseline and how
far vertically the measured point is from the connected line. The baseline can be offset in a horizontal direction
if necessary.
• Before performing setting-out line line, the baseline must be defined.
PROCEDURE
Baseline
Offset (horizontal direction)
Profile View
Measured Point
1st Pt.
S e t - o u t l i n e
I n c r
L i n e
O f f s e t
OFFSET
B a s e l i n e o f f s e t
I n c r
L e n g t h
L a t e r a l
H e i g h t
MOVE
R t . a n g
MOVE
S e t - o u t l i n e
N
E
Z
REC
Measured Point
Offline (--)
Length
Cut
2nd Pt.
70
16. SETTING-OUT LINE
1 . 0 0 0 m
0 . 0 0 0 m
0 . 0 0 0 m
OK
1 . 0 0 0 m
0 . 0 0 0 m
0 . 0 0 0 m
0 . 0 0 0 m
OK
0 . 0 0 0 0
OK
185. 675
102. 482
9. 662
S-O