Sokkia CX Series Operator's Manual page 195

• Width peg: "R" or "L" is added at the end of the center peg point name. "R"
is added for positive (+) route widths (the route width from the center peg to
the RIGHT width peg) and "L" is added for negative (-) route widths (route
width from the center peg to the LEFT width peg). When both route widths
are input as positive (+) "R" and "R2" are used. When both route widths are
input as negative (-) "L" and "L2" are used.
• A blank space at the beginning and end of a point name will be ignored.
• If the length of the point name being input exceeds 16 characters, 1
character at the beginning will be deleted for each new character input at
the end of the point namepoint name.
25.8.6 Arbitrary point calculation
The coordinates of arbitrary points on every calculated curve can be found using
arbitrary point calculation.
PROCEDURE
1. In the second page of the OBS mode
screen, press [MENU], then select
"Road".
2. Select "Alignment" to enter the Route
Calculation menu.
3. Select "Calc coord" to enter the
arbitrary point calculation menu.
4. Input the arbitrary point follow-up
distance.
25. ROUTE SURVEYING
A l i g n m e n t
D e f i n e e l e m e n t s
A u t o c a l c .
C a l c c o o r d
R o a d t o p o
S e t t i n g
A l i g n m e n t / C L p e g
S t a . . i n g
POINT
1 2 3 . 4 5 6 m
OK
185