Setting The Horizontal Angle To A Required Value; (Horizontal Angle Hold) - Sokkia CX Series Operator's Manual

11.2 Setting the Horizontal Angle to a Required Value

(Horizontal Angle Hold)

You can reset the horizontal angle to a required value and use this value to find
the horizontal angle of a new target.
PROCEDURE Entering the horizontal angle
1. Sight the first target.
2. Press [H-SET] on the second
page of the OBS mode and select
"Angle."
3. Enter the angle you wish to set,
then press [OK].
The value that is input as the
horizontal angle is displayed.
• Press [REC] to set and record
the horizontal angle.
"28.2 Recording Backsight
Point"
4. Sight the second target.
The horizontal angle from the
second target to the value set as
the horizontal angle is displayed.
• Pressing [HOLD] performs the same function as above.
• Press [HOLD] to set the displayed horizontal angle. Then, set the angle that is
in hold status to the direction you require.
Allocating [HOLD]: "33.3 Allocating Key Functions"
11. ANGLE MEASUREMENT
Set H angle
Angle
Coord
Set H angle
Take BS
89 59 50
HA-R 347 23 46
HA-R 125.3220
REC
OBS
SD
ZA 8 9 5 9
HA-R 12 5 3 2
MENU TILT H-SET
OK
0
PC
ppm 0
5 0
P2
2 0
EDM
49