Sokkia CX Series Operator's Manual page 94

15. SETTING-OUT MEASUREMENT
4. Enter the coordinates of the
setting-out point.
• When [LOAD] is pressed,
registered coordinates can be
recalled and used as setting-out
coordinates.
"13.1 Entering Instrument
Station Data and Azimuth
Angle PROCEDURE Reading
in Registered Coordinate
Data"
• Pressing [DISP] switches
between the distance input
modes.
5. Press [OK] to set the setting-out
data.
• The tilt screen is displayed if the
instrument is out of level.
Level the instrument.
"7.2 Levelling"
6. The difference in the distance and
angle calculated with the set
instrument station and the target
point is displayed.
Rotate the top of the instrument
until "dHA" is 0° and place the
target on the sight line.
7. Press [MEAS] to begin setting-out
measurement.
The target and the distance of the
point to be set out is displayed (S-
Δ
O HD).
84
S-O Coord
HR
LOAD DISP
S-O HD
H
H
LOAD DISP
S-O HD
dHA
HD
ZA
HA-R
REC DIS
S-O HD
dHA
HD
ZA
HA-R
OK
40.0000
OK
MEAS
C