Sokkia CX Series Operator's Manual page 196

25. ROUTE SURVEYING
5. Press [OK] in the screen shown in
step 4 to display the coordinates and
point name of the arbitrary point.
• The center point can be stored as a
known point in the current job by
pressing [REC].
6. Press {ESC} to return to <Alignment>.
• Press [OFF] to move to the width peg
setting screen.
"25.2 Straight Line Calculation"
• The center peg can be set-out by
pressing [CENTER].
"15. SETTING-OUT
MEASUREMENT"
Rules regarding the automatic assigning of point names to
arbitrary points.
• Arbitrary point: The distance to the arbitrary point is given in terms of the
closest peg No. from the front of the curve. The distance from the peg No.
is added at the end.
• If the length of the point name being input exceeds 16 characters, 1
character at the beginning will be deleted for each new character input at
the end of the point name.
25.8.7 Inverse width peg
The route widths and coordinates for center pegs on every calculated curve can
be found by using inverse width peg calculation.
• There are two methods for specifying arbitrary width peg coordinates: key entry
and observation.
PROCEDURE Using key entry to specify arbitrary width pegs
1. In the second page of the OBS mode
screen, press [MENU], then select
"Road".
186
A l i g n m e n t / C L p e g
N
1 6 7 . 2 8 9
E
1 7 3 . 5 1 7
S t a . . i n g
1 0 0 . 0 0 0 m
N o . 1 2 + 3 . 4 5 6
WIDTH REC S-O CENTER