Figure 104. Installing the FH card holder
Next steps
1.
Install the GPU riser
module.
2. Follow the procedure listed in
Optional serial COM port
Removing the serial COM port
The procedure to remove serial COM port from Riser 2 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Loosen the captive screws on the system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
3. Disconnect the serial COM port cable from the rear I/O board.
96
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.