Dell EMC XC Core XC750xa Installation And Service Manual page 12

Table 5. Rear view of the system (continued)
Item Ports, panels, or
slots
9 VGA port
10 USB 3.0 port (1)
11 iDRAC dedicated
port
12 System
identification button
13 OCP NIC port
(optional)
14 NIC port (1,2)
15 Power supply unit
(PSU 1)
12 Dell EMC XC Core XC750xa system overview
Icon Description
Enables you to connect a display device to the system. For more information,
see the Dell EMC XC Core XC750xa Technical Specifications on the product
documentation page.
This port is USB 3.0-compliant.
Enables you to remotely access iDRAC. For more information, see the iDRAC
User's Guide at www.dell.com/poweredgemanuals.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16 seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID button is
enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold the
system ID button (for more than 5 seconds) to enter the BIOS
progress mode.
N/A This port supports OCP 3.0. The NIC ports are integrated on the OCP card
which is connected to the system board.
The NIC ports are embedded on the LOM card that is connected to the
system board.
For more information about the PSU configurations, see the Dell EMC XC
Core XC750xa Technical Specifications on the product documentation page.