Figure 96. Installing the left GPU riser module
Next steps
1. If removed, install the NVLink sponges.
2.
Replace the rear mounting front PERC
3. Connect the GPU power and signal cables to the system board.
4. Connect the
R1 and R4 paddle cards
5.
Install the cooling fan cage
6.
Replace the air
shroud.
7. Follow the procedure listed in
Removing the GPU
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the NVLink sponges.
4.
Remove the GPU riser
5. If installed, remove the NVLink bridges.
Steps
1. To remove the GPU from GPU riser module:
a. Disconnect the GPU power cable from the GPU card.
b. Open the GPU card holder latches on both ends of the riser.
c. Hold the GPU card by the edges and pull the card from the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
module.
to the system board.
assembly.
After working inside your
Safety
instructions.
Before working inside your
module.
system.
system.
Installing and removing system components
91