Figure 34. Installing a cooling fan
Next steps
1. Follow the procedure listed in
Side wall bracket
Removing the side wall bracket
There are two side wall brackets on either side of the system. The procedure to remove them is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If required,
remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Press the blue side tabs to release the side wall cable holder.
NOTE:
Move the cables out of the side wall cable holder.
2. Press the center tab to release the bracket from the system, and lift it away from the system.
40
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
cover.
shroud.
assembly.
system.
system.