Table of Contents
Advertisement
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan cage
6.
Remove the side wall
Steps
1. Align and slide the right control panel into the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
5. Using the Phillips #1 screwdriver, tighten the screws that secures the right control panel and the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 137. Installing the right control panel
Next steps
1.
Replace the side wall
2.
Replace the cooling fan cage
3.
Replace the drive backplane
4.
Replace the air
shroud.
5. Follow the procedure listed in
122
Installing and removing system components
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
bracket.
assembly.
cover.
After working inside your
instructions.
system.
system.
Advertisement
Table of Contents
