Table of Contents
Advertisement
4. Unlatch and lift or remove the optional cable management accessory if it interferes with the PSU removal.
NOTE:
For information about the cable management when the PSU is removed or installed while the system is in a rack,
see the system's cable management arm documentation at https://www.dell.com/poweredgemanuals.
Steps
Press the release latch and holding the PSU handle, slide the PSU out of the bay.
Figure 127. Removing a power supply unit
Next steps
1.
Replace the power supply unit
Installing a power supply unit
Prerequisites
1. Follow the safety guidelines listed in the
2. For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum
output power.
NOTE:
The maximum output power (shown in watts) is listed on the PSU label.
3.
Remove the PSU
blank.
Steps
Slide the PSU into the PSU bay until the release latch snaps into place.
112
Installing and removing system components
or replace the power supply blank.
Safety
instructions.
Advertisement
Table of Contents
