Table of Contents
Advertisement
Installing the serial COM port
The procedure to install serial COM port on Riser 2 is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
NOTE:
The serial port is supported only in slot 4, slot 5 or slot 6 of the expansion card riser.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the serial COM port into the expansion card riser and close the latch.
Figure 107. Installing the Serial COM port
3. Connect the serial COM port cable to the rear I/O board.
4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated
on the system board connector.
6. Tighten the captive screws on the system.
98
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
