Dell EMC XC Core XC750xa Installation And Service Manual page 127

3. If installing GPU other than T4 into front GPU riser module then,
4. If installing T4 GPU into front GPU riser module then,
5. install the GPU into front GPU riser module or
NOTE: Mixing of different GPUs are not allowed.
NOTE: See Expansion card installation guidelines
NOTE: For information on riser slot location on the system board, see the
6. If applicable, connect the power cables to the GPU. To know the connectors for GPU on the system board, see the
Expansion card installation guidelines
NOTE: Refer to the GPU power cable matrix to know about the requirement of cable for the GPU.
Table 34. GPU power cable matrix
Categor Description
y
GPU CRD,GRPHC,NVI
DIA,T4,16GB,70W
,L
GPU NVIDIA Volta
Next 300W DW
GPU (A100)-Gen
4
GPU Nvidia RTX-A40
HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length
7. Install the GPU riser module
8. Install the air shroud.
After installing, follow the
install the GPU
topic.
Type
HH and HL (FH
and LP brackets)
FH and FL
FH and FL
or expansion card riser. See GPU kit components table for supported GPU risers.
After working inside your system
replace the GPU
install the GPU riser module card
into expansion card riser.
to know about risers and slots that support GPU.
Vendor Cable
NVIDIA Not required
NVIDIA 8 pin cable
NVIDIA 8 pin cable
instructions.
bracket.
holders.
System board jumpers and connectors
Cable quantity
Not required
1 piece per GPU
riser
1 piece per GPU
riser
Upgrade Kits
topic.
Maximum per
system
6
4
4
127