Table of Contents
Advertisement
Figure 131. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing a new system board.
b. IDSDM module (if removed)
c. Internal USB card (if removed)
d.
OCP card (if removed)
e.
Intrusion switch module
f.
Processor and heat sink
g.
Memory modules
h.
BOSS S2 module (if removed)
i.
Serial COM port (if removed)
j.
VGA port (if removed)
k.
R1 and R4 paddle cards
l.
R3 paddle card (if removed)
m.
Expansion card riser
n.
Side wall bracket
o.
Cooling fan cage assembly
p.
Air shroud
q.
Power supply units (PSU)
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the Manually
update the Service Tag by using System Setup section.
c. Update the BIOS and iDRAC versions.
NOTE:
Reenable the Trusted Platform Module (TPM). See the
4. If you are not using Easy restore, import your new or existing iDRAC Enterprise license. For more information, see the
Integrated Dell Remote Access Controller User's Guide available at
5. Follow the procedure listed in
or liquid cooling module
After working inside your
Restoring the system by using Easy Restore
Upgrading the Trusted Platform Module
https://www.dell.com/idracmanuals
system.
Installing and removing system components
section.
section.
.
117
Advertisement
Table of Contents
