Installing The Side Wall Bracket - Dell EMC XC Core XC750xa Installation And Service Manual

Figure 35. Removing the side wall bracket
Next steps
1. Replace the side wall

Installing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to install them is same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If required, remove the drive backplane
4. If installed, remove the air
5. Remove the cooling fan cage
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE: Route the cables through the side wall cable holder.
2. Close the side wall cable holder until the holder clicks into place.
bracket.
Safety
Before working inside your
cover.
shroud.
assembly.
instructions.
system.
Installing and removing system components 41