Table of Contents
Advertisement
Figure 100. Installing GPU on GPU riser module
Next steps
1. If removed, install the NVLInk bridges.
2.
Install the GPU riser
module.
3. If removed, install the NVLink sponges.
4. Follow the procedure listed in
Removing the GPU riser module card holders
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the GPU riser
NOTE:
Your system has either half height (HH) or full height (FH) or without GPU card holder, which is based on the type
of GPU card used.
Steps
Loosen the captive screw and pull out the HH or FH GPU card holder form the GPU riser module.
Figure 101. Removing the HH card holder
94
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
module.
system.
system.
Advertisement
Table of Contents
