Figure 121. Installing the intrusion switch module
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
108
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
riser.
system.
system.