Table of Contents
Advertisement
NOTE:
The procedure to install the liquid cooling rear I/O board and rear I/O board is same.
Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
Figure 134. Installing the LOM card and rear I/O board
Figure 135. Installing the liquid cooling rear I/O board
Next steps
1.
Install the system
board.
2. Follow the procedure listed in
120
Installing and removing system components
After working inside your
system.
Advertisement
Table of Contents
