Figure 78. Installing the expansion card riser (Riser 3)
Next steps
1. If required, re-connect the cables to the expansion card.
2.
Replace the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable, disconnect the cables from the expansion card.
4.
Remove the air
shroud.
5.
Remove the expansion card
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Pull the card holder before removing the card from the riser.
3. Hold the expansion card by the edges. and pull the card from the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
instructions.
Before working inside your
risers.
system.
system.
Installing and removing system components
79