Table of Contents
Advertisement
Mounting to Drywall
If local building codes do not require a wall box, you can mount the touchpanel directly into
drywall.
1.
2.
3.
4.
5.
6.
Mounting the Touchpanels with Optional Kits
A number of kits are available for mounting these touchpanels (see www.extron.com). The kits
must be purchased separately and installed by following the instructions provided with the kit.
Mounting the TLP Pro 525T, 725T or 1025T
The TLP Pro 525T, 725T or 1025T can be placed on any suitable flat surface.
Desktop Mounting
No mounting kit
Figure 24.
For additional security, secure the touchpanel to a table or desk with screws:
1.
2.
3.
SMA-2 Swivel Mount Adapter
The TLP Pro 525T, 725T, and 1025T can be mounted with the optional Extron SMA‑2 swivel
mount adapter, which allows it to be mounted permanently and swivel up to 180° in either
direction. The kit must be purchased separately and installed by following the instructions
provided with the kit.
Go to
www.extron.com
and download the cut‑out template for your touchpanel. Print the
template at 100% size (no scaling).
Remove the gray area in the center of the template, place the template against the wall or
furniture in a suitable location, and ensure that it is level. Use the template to mark the hole
that is being cut and the location of the MK slots (see
Cut a hole in the wall or furniture (see
Drill two pilot holes at the location of the MK slots.
Secure the mounting plate to the wall. Extron recommends using two molly bolts or
SnapToggle bolts.
Complete the installation as described in
NOTE: Extron provides four 3/4" #6‑32 Philips pan head screws for mounting to US
junction boxes and two 16 mm M 3.5 Philips pan head screws for mounting to MK
junction boxes. Screws are usually provided with EU junction boxes.
1 1 1
TLP Pro 725T Base
Under the table top, mark the location of the two mounting holes, 2.71 inches (69 mm) apart
(see figure 24,
). The distance between the mounting holes is the same for all models.
1
Drill two holes through the table top from underneath.
Attach the touchpanel, using two #6‑32 machine screws through the table top from
underneath into the two holes in the base of the touchpanel.
TLP Pro 525, 725, and 1025 Series Touchpanels • Mounting
figure 22
on page 28).
figure
23,
1
, on page 29).
steps 3 through 7
of the previous section.
30
Advertisement
Table of Contents
