Table of Contents
Advertisement
E
F
Connecting Power
These touchpanels must be powered by Power over Ethernet (PoE). Users must provide their
own PoE power injector. Figure 5 shows the Extron XTP PI 100. Your power injector may look
different.
1.
2.
3.
Alternatively, connect the touchpanel to a PoE
switch.
LAN/PoE connector (see
figure 4
powered by Power over Ethernet (PoE; see
ATTENTION:
•
Do not power on the touchpanels or control processors until you have read the
Attention
about Power over Ethernet (PoE) power supplies (see page 13).
•
Ne branchez pas les écrans tactiles ou les processeurs de contrôle avant d'avoir
lu la
mise en garde
page 13).
NOTE:
The touchpanels ship without a power injector. The power injector must be
purchased separately.
An Extron IPL Pro control processor must also be connected to the same network domain
as the TouchLink Pro touchpanel (see the
The network port has two LEDs. The green LED lights steadily to indicate that the
touchpanel is connected correctly to a network. The yellow LED blinks to indicate that data
is being passed to or from the touchpanel.
Speaker —
A single speaker
Connect a straight‑through Ethernet cable from the power injector to a switch or router
(figure 5,
). This cable carries network
1
information from the switch or router to the
power supply.
Connect a second straight‑through cable (
from the power injector to the touchpanel.
This cable carries the network information
and 48 VDC from the power injector to the
touchpanel.
Connect the IEC power cord to a convenient
100 VAC to 240 VAC, 50‑60 Hz power source
(
3
).
TLP Pro 525, 725, and 1025 Series Touchpanels • Panel Features
on the previous page) — These touchpanels must be
Connecting
Power, below).
sur les sources d'alimentation via Ethernet (PoE) (voir
www.extron.com
provides audible feedback for the user.
100-240V
3 3 3
2
)
1 1 1
To network switch
Figure 5.
for a list of suggested models).
~
50-60Hz
0.4A MAX
XTP
XTP PWR
PWR
2 2 2
To touchpanel
XTP PI 100 Power Injector
12
Advertisement
Table of Contents
