Table of Contents
Advertisement
Reset Modes
The touchpanels described in this guide have three reset modes that are initiated by pressing the
RESET
client:
•
•
•
•
The
(see
figure
Use Factory Firmware
This mode is used to boot up the unit with factory‑installed firmware for a single power cycle if a
firmware update fails or incompatibility issues arise with user‑loaded firmware.
Activation
To start the
1.
2.
3.
Result
The unit reverts to factory‑installed firmware. Event scripting does not start if the unit is powered
on in this mode. All user files and settings such as drivers, adjustments, and IP settings are
maintained.
NOTE:
button. An additional (fourth) mode toggles between enabling and disabling the DHCP
Use Factory Firmware (see below).
Reset All IP Settings
(see page 34).
Reset to Factory Defaults
Enable or Disable the DHCP Client
button is found on the rear panel of the TLP Pro 525M, 725M, and 1025M series
RESET
figure 3
B
, on page 8) or the base of the TLP Pro 525T, 725T, or 1025T series (see
4,
, on page 11).
B
Use Factory Firmware
Remove power from the touchpanel.
On the touchpanel, hold down the recessed
re‑applying power to the unit. When power is restored, the
button for a further 2 seconds before releasing it. The touchpanel enters factory
RESET
firmware mode.
Upload new firmware to the unit as desired (see
NOTE:
Do not continue to operate the touchpanel using the factory firmware version. If
you want to use the factory default firmware, you must upload that version again (see
Updating the
Firmware).
To return the unit to the firmware version that was running prior to the reset, cycle
power to the unit.
TLP Pro 525, 725, and 1025 Series Touchpanels • Reference Material
(see page 34).
(see page 35)
reset mode and replace firmware:
button (see
RESET
Updating the Firmware
figure
3,
) while
B
LED lights. Hold the
Reset
on page 26).
33
Advertisement
Table of Contents
