Table of Contents
Advertisement
DSTREAM-XT Getting Started Guide
To obtain optional adapters,
Indicator LEDs on the top
When you power up the DSTREAM-ST unit, the LEDs on top of the unit indicate the status of the
unit.
Figure 2-17: Indicator LEDs
DSTREAM logo
The DSTREAM logo on the top of the unit illuminates and the STATUS LED begins to flash
when you power up the DSTREAM-ST unit. The DSTREAM logo also flashes when you
click the Identify button in the
Firmware Installer view
STATUS
Illuminates green to show that DSTREAM-ST is in its ready state.
If a critical error is detected, the STATUS LED illuminates as continuous red. If the STATUS
LED is red, then you must reset the DSTREAM-ST unit to the factory settings before you can
continue using it. If the DSTREAM-ST unit fails to boot after a reset,
For more information, see
FLASH
Illuminates when the unit is accessing its internal flash storage.
TARGET
Illuminates when a valid target VTREF is detected.
DEBUG
Illuminates when debug data transfer takes place.
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
contact Arm support
Debug Hardware Configure IP view
in Arm Development Studio.
Restore a DSTREAM-XT
Non-Confidential
Document ID: 102443_1.0_00_en
with your requirements.
or the
contact Arm
system.
Version 1.0
The DSTREAM-XT system
Debug Hardware
support.
Page 19 of 38
Advertisement
Table of Contents
